Home > Hardware > CAN-Gateways >
Item #: C.2909.02
Availability: Call For Pricing - (413) 772-3170
Usually ships In 2 Weeks
Gateway CANopen® to PROFIBUS-DP® Slave
Connection of CANopen Devices and Networks to PROFIBUS-DP
- PROFIBUS-DP slave acc. to IEC 61158 (240 bytes input and 240 bytes output)
- CANopen Manager
- Cycle time only limited by PROFIBUS-DP
Extendable with CANopen Modules via InRailBus
- Cable-free connection of esd CAN-CBX I/O modules to the gateway
- InRailBus for CAN connection and power feed
Configuration with Standard Tools
- Run-time configuration via PLC
- No special tools required
- Plug 'n' play replacement
esd is a member of the PNO (PROFIBUS Nutzerorganisation e.V.)
Linking PROFIBUS-DP and CANopen
The CANopen-DP/2 can link any PROFIBUS-DP master to a CANopen network. The gateway operates as a PROFIBUS-DP slave-I/O component with a total of maximum 240 bytes input and 240 bytes output data. It supports cyclic (DP-V0) as well as acyclic (DP-V1) PROFIBUS data transfers. On the CANopen side it operates as a CANopen manager supporting NMT master and configuration functions. PDO and SDO (with SDO timeout and MPDO transmission) data transfers are supported. START frame, SYNC and Heartbeat are controlled by the module.
With the CANopen-DP/2 gateway you can couple CANopen modules e.g. to a SIMATIC-S7. The number of CANopen devices is not limited by the module.
The ISO 11898-compatible CAN interface allows a maximum data-transfer rate of 1 Mbit/s. The PROFIBUS-DP-Slave interface automatically recognizes all usual bit rates up to 12 Mbit/s. The PROFIBUS-DP as well as the CAN interface are electrically isolated.
Configuration and CAN Protocols
The module can be configured via PROFIBUS configuration tool, e.g. the PLC SIMATIC Manager. CANopen is supported as CAN-layer-7 protocol on the CAN layer. Additionally CAN-layer-2 functions are available.